1997 Trans Am WS6
LT1 M6
My Phase 1 Fbody Project
Here is the WS6 patiently waiting for the first phase of the project to start. It is all about the $$. I need to build a better garage before i start. And Save some $$$. I have three kids in college so rich I am not. So hopefully I will be able to score some used parts.
I may need to reel in these plans or spread this out over a few years.
My WS6 Goals
- 375 RWHP
- Low 12s (Hopefully - Atco!)
- Reliable and street driving friendly
- Good handling
- Possible light curvy track use (NJMP!)
- Local Muscle Car shows
Mods so far
- Spec 2 lightweight clutch
- Spec Flywheel
- Hurst Shifter
- CAGS
- Shifter ball
- Unknon muffler or cat back
Swap out
- 1993 T56
- My original trans was destroyed by a tri hitch ball that fell off a truck. He must have forgot the pin. :-(
Mods acquired but not yet installed
- Aluminum LS1 drive Shaft
- Throttle body bypass
Engine Plans
- 233/230 LE Mild cam
- LE2 Heads
- LE ported intake
- Ported MAF
- Ported Throttle Body - 52 mm
- Stock WS6 Intake
- K&N Filter
Exhaust Plans
- LPP Long Tubes (Ebay Headers?)
- Cut out
- Borla catback (Still need cutout?)
Brake/Wheel/Tire Plans
- Corvette front brakes
- LS1 rear brakes (?)
- 18" Corvette C4 Z06 Wheels
- Tires?
Drivetrain Plans
- 12 Bolt (Eventully)
- Driveshaft loop
Suspension Plans
- Koni Shocks
- Lower Control Arms (Worth it?)
- Sway Bars
Appearance Plans
- Fix Headlight cover dent
- Fix driver Quarter
- New driver side Skirt
- Paint
- New middle tail light section
Interior
- Upgraded Stereo (Double Din)
- Upgraded Amp
Fbody Project Phase 2
- LS1 SS Camaro
- 460LE
- Daily Driver